Using The Battery; Recharging The Battery Pack - Pioneer PDV-10 Operating Instructions Manual

Using the Battery

Recharging the battery pack (PDV-LC10 only)
Recharge the battery pack as described below.
1
3
CHARGE
Charger
(VWY 1060)
Note:
The battery charger is compatible with
supply voltages between 100 and 240 V AC
and can be used universally. When you
want to use it on an overseas travel,
however, be sure to prepare a power plug
36 adapter matching the local power outlet.
En
2
Recharge lamp
1
2
Battery pack
(PDV-BT10)
1
Connect the power cord to the
battery charger.
2
Connect the power plug to the
power outlet.
3
Fit the battery pack into the
battery charger.
Fit sections 1 then 2 securely.
• When recharging starts, the recharge
lamp lights in red. If the recharge lamp
blinks, the battery pack is not being
recharged; wait a while before trying to
recharge again.
• The recharge lamp goes out when
recharging completes. After confirming
that the lamp is extinguished, remove
the battery pack and power cord.
• Recharging usually completes in about
2 hours 30 minutes, though this is
variable depending on the operating
conditions.
Notes on the battery pack
• The battery pack can be used for
about 300 cycles of recharging and
operations, though this is variable
depending on the operating
conditions.
• Charge the battery pack fully before
using it for the first time.
CAUTION
• Place the battery charger on a level, flat
surface for recharging.
• Do not short-circuit the terminals of the
battery charger.