Advertisement
Installation
NOTE: Move HearthGate to desired location.
Sections may need to be adjusted again for
proper fit.
12
Lift locking caps and rotate upper and
lower wall brackets until flush against
mounting surface and lower bar housing is
aligned with the upper bracket assembly.
NOTE: Sliding wall bracket assembly is
adjustable for uneven walls and should be
installed as low as possible.
13
With a pencil, lightly outline brackets on
mounting surface.
14
Remove wall plates from brackets by
pressing locking tabs and sliding up.
15
Hold one wall plate with arrow facing up
inside pencil outline and install using two
wood screws. Repeat for all other wall
plates. NOTE: Screws provided are for
mounting directly into wood. If mounting into
brick, drywall or other surfaces, use
appropriate hardware.
16
Attach gate to wall plates by aligning
arrows and inserting round tabs into wall
plates (a). Slide down to lock (b). Tighten bolts
on sliding wall brackets. Gate should now be
properly installed.
12
13
14
15
16
(a)
(b)
Advertisement
