Page of 10

Kidco Safeway G20 User Manual

For openings 24 3/4” to 43 1/2" wide optional 24” extension for opening 43 1/2" to 66” wide.
Hide thumbs
   
Safeway
Gate Model G20 for openings 24
" to 43
wide
1/2"
3/4
TM
Optional 24" extension Model G24 for opening 43 1/2" to 66" wide
Only one extension recommended per gate
User Guide

   Related Manuals for Kidco Safeway G20

   Summary of Contents for Kidco Safeway G20

  • Page 1

    Safeway Gate Model G20 for openings 24 ” to 43 wide 1/2" Optional 24” extension Model G24 for opening 43 1/2" to 66” wide Only one extension recommended per gate User Guide...

  • Page 2

    This product will not necessarily prevent all accidents. Never leave child unattended. Use only spare parts available from KidCo. Never allow child to climb or swing on gate. Use only with the locking /latching mechanism securely engaged.

  • Page 3

    Hinge Side Hardware 2 Hinge bottoms (b) 2 Hinge spindles with locknuts (c) 2 Springs (d) 2 Hinge caps (e) Wood screws (q) 1 Protective plastic cover (r) 4 Expansion screw sockets 4 Expansion screws (g) 1 Wrench (n) Locking Side Hardware 1 Stop pin (s) 1 Locking latch (k) 1 Locking latch bracket (I)

  • Page 4

    Important. Gate must be installed in a structurally sound opening. Hinge side of gate must be mounted to a rigid surface. Ensure mounting surface (wall, stairpost etc.) is strong, rigid and has an even surface. If using gate on a stairway, it must be placed either on top stair or on lowest stair at the bottom.

  • Page 5

    Screw hinge spindles (c) into top and bottom rails of gate section (h) until they are exten- ded equally. These will be adjusted to the correct length at a later stage so do not tighten. Repeat process on gate section (i) using latch spindles (m).

  • Page 6

    As an added safety measure, a stop pin has been provided. Insert stop pin (s) from behind locking latch bracket into hole oppo-site ope- ning direction. Using 2 screws, screw into upper set of screw holes. Correct width will be reached by adjusting gate sections and all four corner spindles.

  • Page 7

    Min: 1” Max: 3” Center gate in opening. Gaps on each side should be equal. Place hinge spindles (c) over hinge bottom posts (b), dropping them into place. Adjust latch spindles (m) out until they fit securely into two locking brackets. Latch spindle at top must be adjusted so it clicks under locking latch when in closed position.

  • Page 8

    A protective plastic cover (r) is provided for top latch spindle. Cut cover, remove latch spindle and put cover on. Return spindle and adjust to correct length. 1 I I I I...

  • Page 9

    * No part of this gate requires lubrication. Clean by sponging with warm water and mild detergent. Do not use abrasive cleaners or bleach. If using outdoors, and to help prevent rust, treat all exposed metal with a rust inhibi- tor.

  • Page 10

    This warranty extends only to the original retail purchaser and is only valid when sup- plied with proof of purchase. KidCo will either repair, or at our option replace, free of charge, any parts necessary to correct defects in material or workmanship during the warranty period. This warranty is complete and exclusive.

This manual also for:

Safeway g24

Comments to this Manuals

Symbols: 0
Latest comments: