Mitsubishi A1SJH(S8) User Manual page 20

1. OVERVIEW
(9)
(10) Two extension connectors, on the right and left sides. (A1SHCPU,A2SHCPU(S1))
(11) Use either screws or DIN rail for panel installations
(12) Easy-to-see terminal block symbol sheet
(13) A
(14) Same programming environment as other MELSEC-A CPU modules
SFC language compatible
An AnSCPU contains a microcomputer program area, so an SFC program can be
used.
In order to facilitate wiring wherever the extension base unit is installed, extension
connectors are provided at both left and right sides of the AnSHCPU and extension
cables that suit the requirements imposed by different mounting locations are
available.
* A1SJHCPU(S8) on the right side only
The AnS base unit is provided both with screw holes and, on its rear face, the fixture
for mounting it to a DIN rail.
• A terminal block symbol sheet is attached to the front of AnS I/O modules.
AnSHCPU writes I/O device numbers, connector numbers, etc. on one side of the
sheet.
• Terminal symbols for 16 I/O signals can be written on the other side.
N, A A-series I/O module and special function module compatible
By connecting an A N, A
modules or special function modules can be used.
A sequence program can be created using the peripheral device currently used for
other MELSEC-A CPU modules. For details on the applicable peripheral devices,
refer to Section 2.2 "Precautions when Configuring the System".
A-series extension base unit, A
1 - 3
N, A A I/O