729/729FC
Users Manual
Error Message
Lost connection to HART
transmitter, Task aborted
Lost connection to FC devices,
Task aborted
Lost connection to RTD, Task
aborted
Open circuit detected
Invalid Task Setting
70
Table 8. Error Messages (cont.)
Explanation
Running task aborted, due to lost connection
to HART transmitter.
Running task aborted, due to lost connection
to Fluke Connect secondary unit.
Running task aborted because RTD was
removed.
Open circuit detected while sourcing mA.
Task setting contains invalid items.
Potential Root Cause
Make sure the transmitter is connected and
powered. Try HART polling again. After
connected, rerun the task.
Turn on the FC secondary device and make
sure FC is active. Redo the discovery
process. After connected, run the task
again.
Make sure the RTD probe is connected and
run the task again.
Connect the circuit properly and try again.
Verify zero/full-scale value defined in the
task are in the range of the selected
pressure source and try again.