Attaching The Mounting Bracket; Safety; Selecting Dowels And Screws; Screw Recommendation - Fronius 10.0-3 208-240 Installation Instructions Manual

Attaching the Mounting Bracket

Safety

Selecting dowels
IMPORTANT! Depending on the surface, different mounting materials may be required for
and screws
installing the mounting bracket. These mounting materials are not part of the scope of de-
livery for the inverter. The installer is responsible for selecting the proper mounting mate-
rials.
Screw Recom- To install the inverter, the manufacturer recommends using steel or aluminum screws with
mendation a diameter of 0.2–0.3 in. (6–8 mm).
Opening the in-
1
1
verter
OFF
Lock
WARNING! An electric shock can be fatal. Danger of residual voltage from ca-
pacitors. Wait until the capacitors have discharged. Discharge takes five minutes.
CAUTION! The inverter can be damaged by soiling or water on the terminals and
contacts of the connection area.
- When drilling, make sure that terminals and contacts in the connection area
do not become soiled or wet.
- The wall bracket without the power stage set does not possess the same de-
gree of protection as the complete inverter and, therefore, should not be at-
tached without a power stage set.
Protect the wall bracket from soiling and moisture during installation.
NOTE! Protection class NEMA4X is only ensured when the inverter is mounted
and firmly screwed into the wall bracket.
The wall bracket without inverter has no NEMA protection.
ON
2
2
11