Don't Overload Generator - Briggs & Stratton 030641-00 Operator's Manual

Building a Cold Weather Shelter
1. Using non combustible material with a fire rating of at least one hour,
build a shelter that will enclose three sides and the top of the generator.
Make sure muffler side of generator is exposed.
NOTICE Contact your local building material supplier for non combustible
materials with a fire rating of at least one hour.
NOTICE Be sure shelter can easily be repositioned for change in wind direction.
2. DO NOT enclose generator any more than shown. Shelter should hold
enough heat created by the generator to prevent icing problem.
NOTICE If a wheel kit is installed on the generator, enlarge shelter
accordingly.
3. Follow steps 3 through 8 as described previously in Creating a
Temporary Cold Weather Shelter.

Don't Overload Generator

Capacity
You must make sure your generator can supply enough rated (running) and surge
(starting) watts for the items you will power at the same time. Follow these simple
steps:
1. Select the items you will power at the same time.
2. Total the rated (running) watts of these items. This is the amount of
power your generator must produce to keep your items running. See
Wattage Reference Guide.
3. Estimate how many surge (starting) watts you will need. Surge wattage
is the short burst of power needed to start electric motor-driven tools or
appliances such as a circular saw or refrigerator. Because not all motors
start at the same time, total surge watts can be estimated by adding only
the item(s) with the highest additional surge watts to the total rated watts
from step 2.
Example:
Rated (Running)
Tool or Appliance
Window AC - 10,000 BTU
Deep Freezer
Television
Security System
Light (100 Watts)
2480 Total Running
Total Rated (Running) Watts
Highest Additional Surge Watts
Total Generator Output Required
Power Management
To prolong the life of your generator and attached devices, it is important to take
care when adding electrical loads to your generator. There should be nothing
connected to the generator outlets before starting its engine. The correct and
safe way to manage generator power is to sequentially add loads as follows:
1. With nothing connected to the generator, start the engine as described
in this manual.
2. Plug in and turn on the first load, preferably the largest load you have.
3. Permit the generator output to stabilize (engine runs smoothly and
attached device operates properly).
4. Plug in and turn on the next load.
5. Again, permit the generator to stabilize.
6. Repeat steps 4 and 5 for each additional load.
14
Additional Surge
Watts (Starting) Watts
1200 1800
500 500
500 —
180 —
100 —
1800 Highest Surge
Watts Watts
= 2480
= 1800
= 4280
NEVER add more loads than the generator capacity. Take special care to
consider surge loads in generator capacity, as described above.
Wattage Reference Guide
Tool or Appliance
Essentials
Light Bulb - 100 watt
Deep Freezer
Sump Pump
Refrigerator/Freezer - 18 cf
Water Well Pump - 1/3 hp
Heating/Cooling
Window AC - 10,000 BTU
Window Fan
Furnace Fan Blower - 1/2 hp
Kitchen
Microwave Oven - 1000 Watt
Coffee Maker
Electric Stove - Single Element
Family Room
DVD/CD Player
VCR
Stereo Receiver
Color Television - 27 in
Personal Computer w/17 in monitor
Other
Security System
AM/FM Clock Radio
Garage Door Opener - 1/2 hp
DIY
Quartz Halogen Work Light
Airless Sprayer - 1/3 hp
Reciprocating Saw
Electric Drill - 1/2 hp
Circular Saw - 7-1/4 in
* Wattages listed are approximate only. Check tool or appliance for actual wattage.
Rated* Additional
(Running) Surge (Starting)
Watts Watts
100 —
500 500
800 1200
800 1600
1000 2000
1200 1800
300 600
800 1300
1000 —
1500 —
1500 —
100 —
100 —
450 —
500 —
800 —
180 —
300 —
480 520
1000 —
600 1200
960 960
1000 1000
1500 1500
BRIGGSandSTRATTON.COM