HP 4200 User Manual page 17

Configuring the IP Address Using the Front Panel
Configuring the IP Address Manually
Configuring the IP Address Using DHCP
These procedures explain how to manually configure an Internet Protocol (IP) address on the appliance using the front
panel. (The TCP/IP page in the web interface
appliance to route print tasks properly.
If the network does not use Dynamic Host Configuration Protocol (DHCP), use the front panel of the appliance to
manually enter the IP address, subnet mask, and default gateway.
To begin configuring the IP address for the appliance, press
Press again to go to the Change Configuration function. (Pressing
The display shows Manual mode. Press
Press to cancel the operation and go to the main display, or press
Press .
Press .
Enter a new password and press
Retype the new password and press
The front panel displays this message briefly.
Press to end the operation and the device will return to the display of normal
operating messages.
Or, after a moment, it will display normal operating messages.
can also be used to do the same.) Configuring the IP address allows the
or to toggle between
.
.
once. The following screen is displayed:
starts the Change Password
DHCP and manual modes.
to continue the configuration process.
process.)