HP 4200 User Manual page 21

Note: The Simple Signaling cable is not included with the appliance or with the APC UPS. This cable
can be ordered from APC (APC part # 940-0020B).
4. Connect the power cable to the power receptacle on the back of the appliance.
Note: Make certain that air flow is not restricted around the back of the unit.
5. Connect the other end of the power cable to a power source. If a UPS is being used, connect the power
cable to the UPS.
6. Turn on the appliance by pressing the Power button on the front panel.
For initial installation, the IP address for the appliance can now be configured. Refer back to the
procedures, or refer directly to information about configuring IP addresses.
Getting Started