Mercedes-Benz S-Class Coupe Operator's Manual page 332

Service products and filling capacities
330
i
The data shown on the vehicle identification
plate is used only as an example. This data is
different for every vehicle and can deviate
from the data shown here. You can find the
data applicable to your vehicle on the vehicle
identification plate.
Vehicle identification number (VIN)
Open the front right-hand door.
X
Fold cover : down and remove it.
X
You will see the VIN.
The VIN can also be found in the following loca-
tions:
on the lower edge of the windshield
R
( page 330)
Y
on the vehicle identification plate
R
( page 329)
Y
Engine number
Engine number (stamped into the crank-
:
case)
VIN (on the lower edge of the windshield)
;
Emission control information plate, includ-
=
ing the certification of both federal and Cali-
fornian emissions standards
Service products and filling capaci-
ties
Important safety notes
G
WARNING
Service products may be poisonous and haz-
ardous to health. There is a risk of injury.
Comply with instructions on the use, storage
and disposal of service products on the labels
of the respective original containers. Always
store service products sealed in their original
containers. Always keep service products out
of the reach of children.
H
Environmental note
Dispose of service products in an environ-
mentally responsible manner.
Service products include the following:
Fuels
R
Lubricants (e.g. engine oil, transmission oil)
R
Coolant
R
Brake fluid
R
Windshield washer fluid
R
Climate control system refrigerant
R
Components and service products must match.
You should therefore only use products that
have been tested and approved by Mercedes-
Benz.
Information on tested and approved products
can be obtained at an authorized Mercedes-
Benz Center or on the Internet at
http://bevo.mercedes-benz.com.
You can identify service products approved by
Mercedes-Benz by the following inscriptions on
the container:
MB-Freigabe (e.g. MB-Freigabe 229.51)
R
MB-Approval (e.g. MB-Approval 229.51)
R
Other designations or recommendations indi-
cate a level of quality or a specification in
accordance with an MB Sheet Number (e.g. MB
229.5). They have not necessarily been
approved by Mercedes-Benz.
Other identifications, for example:
0 W-30
R
5 W-30
R
5 W-40
R