Steering Wheel; Easy Entry/Exit Feature - Mercedes-Benz S-Class Coupe Operator's Manual

Problems with the steering wheel heating
Problem
The steering wheel heat-
ing has switched off pre-
maturely or cannot be
switched on.
EASY-ENTRY/EXIT feature
Important safety notes
G
WARNING
When the EASY-ENTRY/EXIT feature adjusts
the steering wheel and the driver's seat, you
and other vehicle occupants – particularly
children – could become trapped. There is a
risk of injury.
While the EASY-ENTRY/EXIT feature is mak-
ing adjustments, make sure that no one has
any body parts in the sweep of the seat and
the steering wheel.
If there is a risk of becoming trapped by
the steering wheel: move the steering
R
wheel adjustment lever.
the seat: press the switch for seat adjust-
R
ment.
The adjustment process is stopped.
You can stop the adjustment process by press-
ing one of the memory function's position but-
tons. This function is only available on vehicles
with memory function.
G
WARNING
If children activate the EASY-ENTRY/EXIT fea-
ture, they can become trapped, particularly
when unattended. There is a risk of injury.
When leaving the vehicle, always take the
SmartKey with you and lock the vehicle. Never
leave children unsupervised in the vehicle.
G
WARNING
If you drive off while the EASY-ENTRY/EXIT
feature is making adjustments, you could lose
Possible causes/consequences and M Solutions
The on-board voltage is too low because too many electrical consum-
ers are switched on.
Switch off electrical consumers that you do not need, such as the
X
rear window defroster or interior lighting.
control of the vehicle. There is a risk of an
accident.
Always wait until the adjustment process is
complete before driving off.
The EASY-ENTRY/EXIT feature makes getting in
and out of your vehicle easier.
You can activate and deactivate the EASY-
ENTRY/EXIT feature using the multimedia sys-
tem (see the Digital Operator's Manual).
Position of the steering wheel and the
driver's seat when the EASY-ENTRY/
EXIT feature is active
The steering wheel tilts upwards and the driver's
seat moves backwards if you:
remove the SmartKey from the ignition lock
R
with the start/stop button: open the driv-
R
er's door; the ignition must be switched off
with the SmartKey:open the driver's door;
R
the SmartKey must be in position 0 or 1 in the
ignition lock ( page 121)
Y
i
The steering wheel only tilts upwards and
the driver's seat only moves backwards if the
driving position is stored after the seat or
steering column has been adjusted.
The last position of the steering wheel or seat is
stored if:
the ignition is switched off
R
the setting is stored with the memory function
R
( page 103).
Y
i
The steering wheel only moves upwards if it
has not already reached the upper stop. The
driver's seat only moves backwards if it is not
already in the rearmost position.

Steering wheel

Z
99