Raid Adapter Installation; Requirements; Packing List; Installation Instructions - Intel RSP3TD160 Hardware User's Manual

Raid adapters
Table of Contents

Advertisement

Intel® RAID Adapters RSP3TD160, RSP3MD088, RSP3DD080 and RSP3WD080 Hardware User Guide
component side up on to a grounded anti-static surface or conductive foam pad. Do not place electronic
devices on to the outside of any protective packaging.
5.1

RAID Adapter Installation

5.1.1

Requirements

The following items are required to install an Intel® RAID Adapter:
Intel® RAID Adapter
Intel server board based server system with an empty PCIe slot and a Supported Backplane
Internal Tri-Mode data cables. These cables have one dual SF- SFF-8643 on one end and two oculink
connectors on the other end.
SAS, SATA or NVMe drives
5.1.2

Packing List

1 – Intel RAID Module w/snap-on bumper (Pre-Installed)
4 – White Plastic Barrel Stand-offs
4 – White Plastic Locking Pins with pull-tab
Note: Intel RAID Products do not include data cables. Appropriate Tri-Mode data cables may be included
with your server system or must be purchased separately.
5.2
RAID Adapter Installation
5.2.1
Requirements
The following items are required to install an Intel® RAID Adapter:
Intel® RAID Adapter
Intel server board based server system with support for an Intel Integrated RAID Adapter
Internal SAS/SATA data cables
SAS drives or SATA drives
5.2.2
Packing List
1 – Intel RAID Adapter
2– Low profile mounting bracket
3 – Attention Document
4 – Warranty Document
Note: Intel RAID Products do not include SAS / SATA data cables. Appropriate SAS / SATA data cables may
be included with your server system or must be purchased separately.
5.2.3

Installation Instructions

1.
Unpack the Intel® RAID Adapter.
Unpack your RAID Adapter. Inspect it for damage. If it appears damaged, contact your Intel Customer and
Technical Support representative.
2.
Turn off the power to the computer, and disconnect the AC power cord.
3.
Remove the computer cover. Refer to the system documentation for instructions.
4.
Install the RAID Adapter.
a)
Remove the riser card (the adapter can be installed on any riser card)
b) Remove the filler panel
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rsp3md088Rsp3dd080Rsp3wd080

Table of Contents