Switching To Single-Amplifier Operation Mode - Toa SR-C8LWP Operating Instructions Manual

7. SWITCHING TO SINGLE-AMPLIFIER OPERATION MODE

To switch the speaker's bi-amplifier operation mode to single-amplifier operation, remove the speaker's rear
input panel and change the speaker's internal wiring.
Switching Power Modes
Step 1. Remove the four screws securing the input terminal panel and pull out the panel.
Step 2. Pull out a short length of the wiring connected to the back side of the input panel.
Step 3. Disconnect and switch the two pairs of connected connectors so that the two marked and unmarked
connector halves match up.
Step 4. Reinstall the input terminal panel using the four removed screws.
Step 5. Attach the supplied seals to the input terminal panel to change the indication.
5
Changing input terminal panel indication
Input indication seal
for single-amplifier
operation (accessory)
Rating seal for
single-amplifier
operation (accessory)
Panel mounting screws
1, 4
2
Input terminal panel
3
Switching connectors
Mark
9