4IPNET WHG301 User Manual page 81

Rule Item: This rule number of the selected rule. Rule No. 1 has the highest priority; Rule No. 2 has
o
the second priority, and so on.
Rule Name: The rule name can be changed here.
o
Source / Destination – Interface/Zone: There are choices of ALL, WAN1, WAN2, Default and the
o
Service Zones to be applied to the traffic interface.
Source / Destination – IP Address/Domain Name: Enter the source and destination IP
o
addresses.
Source / Destination – Subnet Mask: Enter the source and destination subnet masks.
o
Source / MAC Address: The MAC Address of the source IP address. This is for specific MAC
o
address filter.
Source / Destination – IPSec Traffic: Check the box to filter the encrypted traffic only.
o
Service Protocol: Select a defined protocol from the drop-down list box.
o
Schedule: Defines the time when this firewall rule will be activated. When a schedule is selected,
o
the clients assigned to this Policy are applied with the firewall rule only within the time selected.
There are three options, Always, Recurring and One Time.
Action for Matched Packets: There are two options, Block and Pass. Block is to prevent packets
o
from passing, while Pass is to permit packets passing.
Ø Specific Route Profile: The default gateway of WAN1, WAN2, or a desired IP address can be defined in a
Policy. When Specific Default Route is enabled, all clients applied with this Policy will access the Internet
through this default gateway.
Click Setting of Specific Route Profile to enter the Specific Route page for further configuration.
76
4ipnet WHG301 User's Manual
© 2008 4IPNET, INC.