4IPNET WHG301 User Manual page 40

Click Configure button to configure each Service Zone: Basic Settings, SIP Interface Configuration,
Authentication Settings, Wireless Settings, and Managed AP in Each Service Zone.
Service Zone Settings – Basic Settings
1)
Ø
Service Zone Status: Each service zone can be enabled or disabled except for the default service zone.
Ø
Service Zone Name: The name of service zone could be input here.
Ø
Network Settings:
Operation Mode: Contains NAT mode and Router mode. When NAT mode is chosen, the service
o
zone runs in NAT mode. When Router mode is chosen this service zone runs in Router mode.
IP address: The IP Address of this service zone.
o
Subnet Mask: The subnet Mask of this service zone.
o
Ø
DHCP Server Settings: Related information needed on setting up the DHCP Server is listed here. Please
note that when "Enable DHCP Relay" is enabled, the IP address of clients will be assigned by an external
DHCP server. The system will only relay DHCP information from the external DHCP server to downstream
clients of this service zone.
Start IP Address / End IP Address: A range of IP addresses that built-in DHCP server will assign
o
to clients. Note: please change the Management IP Address List accordingly (at System
Configurationà System Information à Management IP Address List) to permit the administrator to
access the WHG301 admin page after the default IP address of the network interface is changed.
Preferred DNS Server: The primary DNS server that is used by this Service Zone.
o
Alternate DNS Server: The substitute DNS server that is used by this Service Zone.
o
Domain Name: Enter the domain name for this service zone.
o
35
4ipnet WHG301 User's Manual
© 2008 4IPNET, INC.