4IPNET WHG301 User Manual page 78

Rule Number: This is the rule selected "1". Rule No. 1 has the highest priority; rule No. 2 has the
o
second priority, and so on.
Rule Name: The rule name can be changed here.
o
Source/Destination – Interface/Zone: There are choices of ALL, WAN1, WAN2, Default, and
o
the named Service Zones to be applied for the traffic interface.
Source/Destination – IP Address/Domain Name: Enter the source and destination IP addresses.
o
Domain Host filtering is supported but Domain name filtering is not.
Source/Destination – Subnet Mask: Select the source and destination subnet masks.
o
Source- MAC Address: The MAC Address of the source IP address. This is for specific MAC
o
address filter.
Source/Destination – IPSec Encrypted: Check the box for only filtering on the encrypted traffic.
o
Service Protocol: There are defined protocols in the service protocols list to be selected.
o
Schedule: When schedule is selected, clients assigned with this policy are applied the firewall rule
o
only within the time checked. There are three options, Always, Recurring and One Time.
Recurring is set with the hours within a week.
Action for Matched Packets: There are two options, Block and Pass. Block is to prevent
o
packets from passing and Pass is to permit packets passing.
Ø Specific Route Profile: Click the button of Setting for Specific Route Profile, the Specific Route Profile
list will appear.
Route No.: The number of route.
o
IP Address (Destination): The destination IP address of the host or the network.
o
Subnet Netmask: Select a destination subnet netmask of the host or the network.
o
IP Address (Gateway): The IP address of the next router to the destination.
o
73
4ipnet WHG301 User's Manual
© 2008 4IPNET, INC.