Benelli Tornado Naked TRE TR 160 2011 Owner's Manual page 183

6 • MAINTENANCE
Check the pressure according to the values indicated in the table below:
Front cool tyre
Back cool tyre
In the event of long travels, you can increase the face value of the tyre pressure of 0.2 bar. It is extremely important to check the wear
of the tyres before riding. In fact, a worn out tyre can be punctured more easily than a new one, and it can adversely affect handling
and stability of the motorcycle. Check that the depth of the tyre tread is not below the values prescribed by the Highway Code.Verify
the absence of crevices at the bottom of the tread design and fissures on the tyre sidewall. Moreover, verify the absence of nails and
glass splinters in the tyre. If these conditions are not verified, have the tyre replaced by anauthorized Benelli Q.J. dealer.
If a tyre is punctured it must be replaced, not repaired. A repaired tyre provides a restricted performance
and lower safety levels than a new one. If you make a provisional or emergency repair to a tyre, you
must ride at very low speed until you reach the nearest Benelli Q.J.authorized service center and have
the tyre replaced. With a provisionally repaired tyre, never exceed 60 km/h (37.2 Mph). Tyre repairing must
never be performed if the tyre is punctured onits sidewall, or if the diameter of the puncture on the tread
is greater than 6 mm (0.23 in).
250 kPa (2,5 bar)
250 kPa (2,5 bar)
82
MAINTENANCE
Pressure