Benelli Tornado Naked TRE TR 160 2011 Owner's Manual page 127

3 • CONTROLS AND INSTRUMENTS
Engine stop switch
It is used to switch off the engine in an emergency. The ignition circuit is disabled, preventing the engine from being restarted. To be
able to restart the engine, return the switch to the "ON" position.
Under normal conditions, do not use this switch to shut off the engine.
Front brake lever
It controls a hydraulic circuit that operates the front wheel braking system.
Throttle twist grip
It controls the fuel-air mixture supplied to the engine, which regulates engine speed. To increase engine speed,rotate the hand
grip from its idle position counterclockwise.
Engine start button
This device permits the motor starting, pushing the steering clutch , if it is used 3 seconds after the motor starting, you can use the
display functions.
To avoid damaging the electrical equipment, be sure not to hold down the button for longer than 5
consecutive seconds. If, after some attempts, the engine does not start, contact your authorized Benelli Q.J.
service center.
26
CONTROLS AND INSTRUMENTS