Installing An Option Card; Figure 5-6: Eisa, Isa, And Pci Option Cards - Compaq AlphaServer 1000A Owner's Manual

Installing and Removing Components

Installing an Option Card

To install an EISA, ISA, or PCI option card on the system board, refer to Figure 5-6 and
Figure 5-7, and perform the steps below.
__________________________ Note _____________________________
To install a high-performance graphics option card, you must disable the SVGA
jumper (J27) on the system board. Figure 9-5 in Chapter 9, "Quick Reference"
shows the jumper location.
____________________________________________________________
_________________________Caution____________________________
Static electricity can damage electronic components. Use an antistatic wriststrap
when you handle these components. (See the section "Antistatic Precautions.")
____________________________________________________________
1. Select a vacant option card slot on the system board. The top three slots are reserved
for PCI options; the bottom eight are for EISA or ISA options. Figure 5-6 shows the
three kinds of option cards.

Figure 5-6: EISA, ISA, and PCI Option Cards

5-10 AlphaServer 1000A Rackmount Owner's Guide
ISA
EISA
PCI
MLO-011569