NCS Cirrus LT User Manual page 87

Enable in Session
Enabling this mode will put the unit to sleep within the selected amount of time
of inactivity even if in a remote session.
To Enable In Session Mode:
1. Click the Power Management submenu.
2. Click the box next to Enable In Session. When the green 'check mark' is
selected, Enable In Session Mode will then be turned on.
To Disable In Session Mode:
1. Click the Power Management submenu.
2. Click the box next to Enable In Session. When the gray 'X' is selected, En-
able In Session Mode will be turned off.
Cirrus LT User Manual v2.3 - Chapter 4
87