Jeep Compass2018 Owner's Manual page 125

124 GETTING TO KNOW YOUR INSTRUMENT PANEL
If the ABS light does not turn on when the ignition is
placed in the ON/RUN or ACC/ON/RUN position, have
the brake system inspected by an authorized dealer.
— Electronic Park Brake Warning Light
This telltale will turn on to indicate the Electronic Park
Brake is not functioning properly and service is required.
Contact your authorized dealer.
— Fuel Cutoff Warning Light — If Equipped
This telltale will illuminate after an accident has occurred,
and the system has shut the fuel off.
— LaneSense Warning Light — If Equipped
The LaneSense Warning Light will be solid yellow when
the vehicle is approaching a lane marker. The warning light
will flash when the vehicle is crossing the lane marker.
Refer to "LaneSense — If Equipped in "Starting And
Operating" for further information.
— LaneSense Fault Warning Light — If Equipped
This light will turn on when the LaneSense system is not
operating and needs service. Please see your authorized
dealer.
— Low Coolant Level Warning Light
This telltale will turn on to indicate the vehicle coolant
level is low.
— Low Fuel Warning Light
Depending on whether the tank size is 51L or 60L, the Low
Fuel Indicator Light will turn on when the fuel level goes
below 1.5 gal (5.6L) or 1.7 gal (6.6L) respectively.
— Low Washer Fluid Warning Light — If
Equipped
This indicator will illuminate when the windshield washer
fluid is low.
— Engine Check/Malfunction Indicator Warning
Light (MIL)
The Engine Check/Malfunction Indicator Light (MIL) is a
part of an Onboard Diagnostic System called OBD II that
monitors engine and automatic transmission control sys-
tems. The light will illuminate when the ignition is in the
ON/RUN position before engine start. If the bulb does not
come on when turning the ignition switch from OFF to
ON/RUN, have the condition checked promptly.
Certain conditions, such as a loose or missing gas cap, poor
quality fuel, etc., may illuminate the light after engine start.