Towing The Vehicle - Mercedes-Benz Light Truck ML 320 Operator's Manual

6. After the engine has started, remove
jumper cables by exactly reversing
the above installation sequence,
starting with the last connection
made first. When removing each
clamp, make sure that it does not
touch any other metal while the
other end is still attached.
Important!
A discharged battery can freeze at
approx. +14°F (-10°C). In that case, it
must be thawed out before jumper
cables are used. A frozen battery can
explode and cause personal injury.
Jumper cable specifications:
• Minimum cable cross-section of
2
25 mm or approx. 2 AWG
• Maximum length of 11.5ft.
(3.5 m).
Note:
If engine does not run after several
unsuccessful starting attempts, have it
checked at the nearest authorized
Mercedes-Benz dealer. Excessive
unburned fuel may damage the
catalytic converter.

Towing the Vehicle

1 Towing eye, front
The front towing eye is located on the
passenger side below the bumper.
2 Towing eye, rear
The rear towing eye is located behind
behind the left side cover in the bumper
panel.
Coyer removal:
Using a flat blade screwdriver pry
out the cover.
Cover installation:
Engage the cover at bottom and
press in top securely.
121