Vehicle Jack - Mercedes-Benz Light Truck ML 320 Operator's Manual

Warning!
The jack is designed exclusively for
jacking up the vehicle at the jack
take-up brackets built into either
side of the vehicle. To help avoid
personal injury, use the jack only to
lift the vehicle during a wheel
change. Never get beneath the
vehicle while it is supported by the
jack. Keep hands and feet away from
the area under the lifted vehicle.
Always firmly set parking brake and
block wheels before raising vehicle
with jack.
Do not disengage parking brake
while the vehicle is raised. Be certain
that the jack is always vertical when
in use, especially on hills. Always try
to use the jack on level surface. Be
sure that the jack arm end is fully
seated in the jack take-up bracket.
Always lower the vehicle onto
sufficient capacity jackstands before
working under the vehicle.
Vehicle Jack, Wheel Bolt Wrench
and Screwdriver
The vehicle jack, wheel bolt wrench
and screwdriver are located in the rear
cargo compartment behind the door in
the right side trim panel.
To get to tools, first remove trim panel
door by turning both handles to left,
and then swing aside CD-player (if so
equipped).
Unscrew plastic nut (1) and lift out

vehicle jack.

See illustration for proper storage of jack
and wheel bolt wrench.
107