Table of Contents
Advertisement
Input
You install an input module by sliding the module into a module slot in the
upper section of the headend unit and click the module into place.
You can remove an input module from a module slot without using any tools,
just use your fingers.
Each input module has a LED on the front to signal whether the module is
locked or not to the frequency that it is set to receive at.
Green - flashing
Green
Red
No colour
When you update the software of a module the status LED provides you with
information about the updating process.
The module has not been configured yet.
No errors and the tuner is locked to the frequency.
Error and the tuner is not locked to the frequency.
Power has not been switched on.
10
Advertisement
Table of Contents
