Table of Contents
Advertisement
4
Troubleshooting
4.1
Software error codes
Consult this section if you are a PicoScope or PicoLog user. If you are writing your own
program, refer to the
PicoLog reports error code
This error is reported when you try to open more than 4 PicoScope PC Oscilloscopes on
one machine. It is not possible to use more than 4 units with PicoLog.
PicoScope or PicoLog reports error code
This error is reported when the driver cannot allocate enough of the computer's
memory to operate the unit. Consult the
information.
PicoScope or PicoLog reports error code
This error indicates that a PicoScope 2000 Series PC Oscilloscope could not be found
on your machine. Make sure the software is installed before the unit is plugged into
the USB socket, and restart your computer.
Ensure that the Windows Device Manager mentions the PicoScope 2000 Series unit. If
the unit is not mentioned there, contact Pico Technical Support for further advice.
PicoScope or PicoLog reports error code
These errors are reported when there is a problem with the unit itself. They could arise
from configuration settings being corrupted, or a firmware or hardware error.
Unplug the unit, wait a few seconds, and reconnect it to the USB port. If the error is
still reported, consult Pico Technical Support for further advice.
PicoScope or PicoLog reports error code
This error is reported if the operating system is not recent enough to support the
PicoScope 2000 Series PC Oscilloscope. Consult the
more information.
Copyright 2006 Pico Technology Limited. All rights reserved.
driver error codes
section.
.
1
Troubleshooting
.
2
system requirements
.
3
,
or
.
4
5
6
.
7
system requirements
27
section for more
section for
PS2100044-1.0
Advertisement
Table of Contents
