Microsd Card; Battery Pack - NTT docomo F-05D Instruction Manual

Table of Contents

Advertisement

■ Removing
1
Press the lock with your finger (a) and pull
docomo mini UIM card out 2-3 mm toward
b
2
Lift your finger from the lock, press docomo
mini UIM card lightly and slide it toward b
Do not press docomo mini UIM card downward
forcefully.
b
✔INFORMATION
When handling docomo mini UIM card, take care not to
touch or scratch the IC part. Note that inserting docomo
mini UIM card forcibly into the terminal may damage
docomo mini UIM card.
◆ Security codes of docomo mini UIM
card
There is a security code called PIN code in the docomo
mini UIM card. The code is set to "0000" at subscription,
which you can change by yourself.→P47
a
Lock

Battery pack

◆ Attaching/Removing battery pack
Attach/Remove the battery pack after turning OFF the
power.
When you attach/remove the back cover, hold the
terminal in your hand so that you will not scratch the
display etc.
If the terminal gets wet, wipe off water before removing
the back cover.
Use Battery back F24 dedicated to the terminal.
■ Attaching
a Put your fingernail into the back cover removing part
a and lift the back cover vertically until the one side
goes off
25
Back cover removing part
Before using the terminal

Advertisement

Table of Contents
loading

This manual is also suitable for:

Arrows x lte next series

Table of Contents