Table of Contents
Advertisement
86
AP 7181 Access Point: Installation Guide
4.3 FCC Regulatory Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received;
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
•
Do not touch or move the antenna(s) while the unit is transmitting or receiving.
•
Do not hold any component containing a radio such that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
•
Do not operate a portable transmitter near unshielded blasting caps or in an explosive environment
unless it is a type especially qualified for such use.
•
Do not operate the radio or attempt to transmit data unless the antenna is connected; otherwise, the
radio may be damaged.
4.3.1
RF Exposure
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 centimeters between the
radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20cm from
all persons and must not be located or operating in conjunction with any other antenna or transmitter.
To comply with FCC RF exposure compliance requirements, a separation distance of at least 33.9cm must be
maintained between the user and antenna.
4.3.2
Intentional and Unintentional Radiators
Changes or modifications not expressly approved by Motorola could void the user's authority to operate the
equipment.
4.4 Canada Requirements
This Class B digital apparatus complies with Canadian ICES-003.
For AC powered units use only the Motorola approved internal power supply rated at 48V output. Typical
power is 84 watts average and 126 watts peak. Use of alternative power supply will invalidate any approval
given to this device and may be dangerous.
Advertisement
Table of Contents
