Motorola AP 7181 Installation Manual page 70

Hide thumbs Also See for AP 7181:
Table of Contents

Advertisement

64
AP 7181 Access Point: Installation Guide
7. If using the static or DHCP Server option, enter a
numerical IP address of a router the access point uses as a default gateway on the
Ethernet.
8. If using the static or DHCP Server option, enter the
IP address.
9. If using the DHCP Server option, use the
to specify a range of addresses to be reserved for mapping clients to IP addresses.
NOTE
WLAN Quick Configuration
The Quick Setup page includes a WLAN section to support WLAN creation. By default,
a single WLAN is configured as ESSID 101, Open, Available on both radios.
1. WLANs 1-4 are available on the Quick Setup screen. Select the
define its ESSID and security scheme for basic operation.
a. Enter the
associated with the WLAN. This name is will be identified by 802.11 stations
when searching for a network to connect to.
b. Use the
operating in the 2.4 or 5.x GHz radio band. Ensure the radio selected has been
enabled.
2. Once the WLAN's radio designations have been made, the radio must be
configured in respect to intended 2.4 or 5 GHz radio traffic and the antennas used.
Select
Network Configuration -> Wireless -> Radio Configuration -> Radio1
(or Radio2), and configure the Radio Settings field. If you know the Properties,
Performance and Beacon Settings for the radio, define those fields. Otherwise you
can accept the factory default settings.
3. Define the Channel Settings, Power Level and 802.11 mode with respect to the 2.4
or 5.x GHz 802.11b/g/n or 802.11a/n radio traffic and anticipated gain of the
antennas.
If a manually (static) mapped IP address is within the IP address
range specified, that IP address could still be assigned to another
client. To avoid this, ensure all statically mapped IP addresses are
outside of the IP address range assigned to the DHCP server.
Extended Services Set Identification (ESSID)
checkboxes to define whether the target WLAN is
Available On
Default Gateway
Primary DNS Server
Address Assignment Range
to define the
numeric
parameter
tab to
WLAN #1
and the name

Advertisement

Table of Contents
loading

Table of Contents