Voice Control; Hold Function - Telematrix SIP 9600IP User Manual

Redial
Volume +
Volume -
Flash
1
2
3
4
5
6
7
8
9
0
*
#
2.2.1 Store numbers
Press "STORE" key to enter into the setting state of storing keys, and input
storing number, then press the corresponding storing key to store the numbers.

2.2.2 Voice Control

Pressing "VOL+" to increase the volume, and press "VOL-" to decrease the
volume.

2.2.3 Hold Function

It is used for holding the current line or forwarding to other handset, for
example:
When you use the #1 handset and want to use the #2 in a call, now you need
Dialing Redial the number of last time
Call Increase the volume
Call Reduce the volume
Off-Hook Quickly cut off the current line and off-hook
again.
Dialing "1"
On-Hook Long pressing can pick up the message
Dialing "2"
On-Hook Long pressing can call the number stored in
mem6 on the base unit
Dialing "3"
On-Hook Long pressing can call the number stored in
mem7 on the base unit
Dialing "4"
Off-Hook Long pressing can call the number stored in
mem8 on the base unit
Dialing "5"
On-Hook Long pressing can call the number stored in
mem9 on the base unit
Dialing "6"
On-Hook Long pressing can call the number stored in
mem10 on the base unit
Dialing "7"
Dialing "8"
Dialing "9"
Dialing "0"
Dialing "*"
On-Hook Long pressing for 3 seconds entering into the
registration status of the handset
Dialing It can be regarded as the first number being
dialed out or the end mark for ending
number.
8