Toshiba MML-AP0124H2UL Service Manual page 70

No. Spare parts
Refrigerant 1. Detachment
cycle (1) Recover the refrigerant gas.
assembly (2) Take off the connecting pipe.
(3) Following to works 1 of
(4) Take off the reinforcement plate.
(5) Remove the upper panel )
(6) Remove the vertical grille.
(7) Remove the shield plate for heat exchanger (Front).
(8) Remove the shield plate for heat exchanger (Right).
(9) Take off the screws which fix the heat exchanger.
(10) Remove the shield plate.
(11) Slide the heat exchanger horizontally, release
2. Attachment
Following step 1 of
the parts as original in the reverse procedure.
Drain pan 1. Detachment
assembly (1) Following step 1 of
(2) Remove the drain pan assembly.
2. Attachment
Following step 1 in
the parts as original in the reverse procedure.
PMV motor 1. Detachment
(1) Following step 1 of
(2) Peel bityl rubber which is adhered to the PMV body,
2. Attachment
Following step 1 of
as original by the reverse procedure.
* Control the tightening torque between PMV body and
PMV motor at 5.8 ± 0.7 ft•lbs (7.84 ± 0.98 N•m).
Work procedure
(Liquid pipe and gas pipe)
the parts.
(M4 screw: 2 pieces)
(M4 screws: 4 pieces)
(M4 screws: 4 pieces)
(M4 screws: 3 pieces)
(M4 screws: 3 pieces)
(M4 screws: 4 pieces)
(M4 screws: 2 pieces)
liquid pipe, gas pipe from the drain pan, and then
pull out it to the upper side.
and those in (1) to (11), attach
and those in (1) to (11),
detach the parts.
and those in (1) to (2), attach
and those in (3) to (8),
detach the parts.
loosen the nut fixing the PMV motor with a double
spanner, and then remove the PMV motor.
and (1) to (2), attach the parts
, and (1) to (10), detach
– 70 –
Remarks
PMV motor
PMV body