Toshiba MML-AP0124H2UL Service Manual page 46

Changing of settings for Celsius display
• Push ON / OFF button if the unit stops.
Procedure 1
Push simultaneously
After a while, the display part flashes as shown right. Check the displayed CODE No. is [
• When the CODE No. is other than [
first step. (After pushing
(For a group control, No. of the firstly displayed indoor unit becomes the header unit.)
Procedure 2
Every time the button is pushed,
in the group control is displayed in order. Select the indoor unit of which setup
is changed.
In this time, the position of the indoor unit of which setup is changed can be
confirmed because fan of the selected indoor unit will operate.
Procedure 3
1. Using temp. setup
33
(CODE No. [ ]: Fahrenheit display)
2. Using timer buttons, change the line address from [
3. Push button. In this time, the setup finishes when the display changes
from flashing to lighting.
Procedure 4
After verifying the content change, push
When pushing button, the display disappears and the status becomes the usual stop status.
(When pushing button the operation from the remote control is not accepted for approx. 1 minute.)
• If the operation from the remote control is not accepted after 1 minute of pushing the
that the address setup is incorrect. In this case, the automatic address must be set up again.
When changing the settings from Celsius to Fahrenheit follow the reverse order of the above procedure.
+ + buttons for 4 seconds or more.
10
], push
button, operation of the remote control is not accepted for approx. 1 minute.)
4
5
6
1
(button at left side), the indoor unit No.
UNIT LOUVER
buttons, specify CODE No. [
button. (Setup is determined.)
button to erase the display and repeat procedure from the
33
].
0001 0000
] to [
– 46 –
10
].
3
2
SET DATA SETTING
UNIT No.
R.C. No.
SET DATA SETTING
UNIT No.
R.C. No.
]
SETTING
button, it is considered
CODE No.
CODE No.