Toshiba MML-AP0124H2UL Service Manual page 41

How to change an indoor unit address by using a wired remote control
Use this method to change the address of indoor units (one to one or group control) that have had the original
address set automatically.
This procedure must be done while the units are not operating.
1
Simultaneously push and hold the "SET
than 4 seconds. If there are 2 or more units in a group, the first "UNIT No." indicated is the
header unit.
2
Push the left end of the "UNIT LOUVER
address to change. If 2 or more units are controlled in a group the fan of the selected unit
will be energized.
3
Push the TEMP.
4
Push the TIME
section.
5
Push the "SET
6
Push left and of the "UNIT LOUVER
addresses to change. Repeat steps 4 through 6 to continue changing indoor unit address
and make each of them unique.
7
Push the left end of the "UNIT LOUVER
addresses.
8
If the addresses have been changed correctly, push the "TEST
procedure.
/ buttons repeatedly to select
/ buttons repeatedly to change the value indicated in the SET DATA
" button, to save address.
UNIT LOUVER
SET DATA 00 00
SETTING
3
TEMP.
5
TIMER SET
8
FILTER
RESET
Fin
1
", "CL ", and "TEST
" button repeatedly to select an indoor unit
UNIT LOUVER
13 13 13 13 13 for CODE No.
" button repeatedly to select another indoor unit
" button to review/confirm the revised
UNIT LOUVER
10
CODE No.
UNIT No.
- 1
R.C. No.
ON / OFF
FAN MODE
TIME SAVE VENT
CL SWING/FIX
2, 6, 7
– 41 –
" buttons for more
" button to finish the
4