Table of Contents
Advertisement
15
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
213
To define and view IP Multicast groups:
Click Multicast > IP Multicast Group Address.
The page contains all of the IP Multicast group addresses learned by snooping.
Enter the parameters required for filtering.
•
VLAN ID equals to—Define the VLAN ID of the group to be displayed.
•
IP Version equals to—Select IPv6 or IPv4.
•
IP Multicast Group Address equals to—Define the IP address of the
Multicast group to be displayed. This is only relevant when the Forwarding
mode is (S,G).
•
Source IP Address equals to—Define the source IP address of the sending
device. If mode is (S,G), enter the sender S. This together with the IP Group
Address is the Multicast group ID (S,G) to be displayed. If mode is (*.G), enter
an * to indicate that the Multicast group is only defined by destination.
Click Go. The results are displayed in the lower block.
Click Add to add a static IP Multicast Group Address.
Enter the parameters.
•
VLAN ID—Defines the VLAN ID of the group to be added.
•
IP Version—Select the IP address type.
•
IP Multicast Group Address—Define the IP address of the new Multicast
group.
•
Source Specific—Indicates that the entry contains a specific source, and
adds the address in the IP Source Address field. If not, the entry is added as
a (*,G) entry, an IP group address from any IP source.
•
IP Source Address—Defines the source address to be included.
Click Apply. The IP Multicast group is added, and the device is updated.
To configure and display the registration of an IP group address, select an address
and click Details.
The VLAN ID, IP Version, IP Multicast Group Address, and Source IP Address
selected are displayed as read-only in the top of the window. You can select the
filter type:
•
Interface Type equals to—Select whether to display ports or LAGs.
Cisco Small Business 200 Series Smart Switch Administration Guide
Adding IP Multicast Group Addresses
Multicast
Advertisement
Table of Contents
