Ip Multicast Group Addresses - Cisco Small Business 200 Series Administration Manual

Multicast

IP Multicast Group Addresses

• MAC Group Address—The MAC address of the group.
STEP 7
STEP 8
STEP 9
• Static—Attaches the interface to the Multicast group as a static member.
• Dynamic—Indicates that the interface was added to the Multicast group as a result of IGMP/MLD
snooping.
• Forbidden—Specifies that this port is not allowed to join this Multicast group on this VLAN.
• None—Specifies that the port is not currently a member of this Multicast group on this VLAN.
STEP 10
Entries that were created in the IP Multicast Group Address page cannot be deleted in this page
NOTE
(even if they are selected).
IP Multicast Group Addresses
The IP Multicast Group Address page is similar to the MAC Group Address page except that Multicast
groups are identified by IP addresses.
The IP Multicast Group Address page enables querying and adding IP Multicast groups.
To define and view IP Multicast groups:
STEP 1
The page contains all of the IP Multicast group addresses learned by snooping.
STEP 2
• VLAN ID equals to—Define the VLAN ID of the group to be displayed.
• IP Version equals to—Select IPv6 or IPv4.
• IP Multicast Group Address equals to—Define the IP address of the Multicast group to be displayed.
This is only relevant when the Forwarding mode is (S,G).
Cisco Small Business 200 Series Smart Switch Administration Guide
Select either port or LAG from the Filter: Interface Type menu.
Click Go to display the port or LAG membership of the VLAN.
Select the way that each interface is associated with the Multicast group:
Click Apply, and the Running Configuration file is updated.
Click Multicast > IP Multicast Group Address.
Enter the parameters required for filtering.
17
214