Connecting Two or More Cameras—Multi-Camera System
Notes on multi-camera system
Perform the following to prevent flicker when switching
between two or more cameras connected to a video switcher:
Supply the same sync signal to the GENLOCK IN
connectors on each camera adaptor (see below).
Sync signal generator
Sync (VBS or BS)
output
VBS OUT
Switcher, etc.
VIDEO IN
Video monitor,
VTR, etc.
75-ohm coaxial cable
VIDEO
DXC-390
OUT
VIDEO OUT
DC IN/VBS
TRIG IN
LENS
MENU LOCK
OFF
ON
RGB/SYNC
REMOTE
VIDEO IN
DC IN/VBS
VBS OUT
75-ohm coaxial cable
VIDEO OUT
DXC-390
VIDEO OUT
DC IN/VBS
TRIG IN
LENS
MENU LOCK
OFF
ON
RGB/SYNC
REMOTE
DC IN/VBS
Adjust the subcarrier and horizontal synchronization
phases for all cameras.
For more details, see "Adjusting the Picture Tone in a
Multi-Camera System" on page 37.
Set the MODE selector
1
to the "1" position.
2
GENLOCK IN
CAMERA (12-pin)
CCMC-12P02/05/10/25 cable
Set the MODE selector
1
to the "1" position.
2
GENLOCK IN
CAMERA (12-pin)
CCMC-12P02/05/10/25 cable
Chapter 3 Installation and Connections
CMA-D2 camera
adaptor
Power cord
CMA-D2 camera
adaptor
Power cord
45
(GB)