Remington EYE BALL R1 Owner's Manual page 20

18
Using
D. Control the Remote Viewer
To do this...
Switch between RVs
Resume operation from Standby
Reduce RV power consumption
when video isn't needed
Nudge RV about 10°
Nudge RV about 30°
Start continuous rotation
Stop continuous rotation or scan
Turn illumination on or off
Set illumination to auto
Mute or hear audio
Adjust audio volume
Adjust video contrast
Adjust video brightness
Zoom in or out
Flip display vertically
Turn off display to conserve
power
Turn on display
Turn off PDU and place RVs in
standby
Change channel to optimize
video/audio or avoid interfering
with another device
Do this...
Momentarily press Standby button
Momentarily press Standby button
Press and hold Standby button
seconds) until Standby indicator is on (places
both RVs in Standby Mode).
While RV is not rotating, momentarily press a
Direction button
While RV is not rotating, press and hold (about 2
seconds) a Direction button
Momentarily press Rotation On/Off button
(Rotation will be in last direction in which RV was
nudged.)
Momentarily press Rotation On/Off button
or either Direction button
Momentarily press Illumination button
indicator shows desired state.
Press and hold Illumination button
indicator turns on.
Press Mute button
Press – or + Volume button
Press – or + Contrast button
Press – or + Brightness button
Press Zoom button
Press Flip button
Press and hold Flip button
Press and hold Flip button
Press Power button
Press Channel button
.
to select RV.
(about 3
or .
or .
.
until Auto
.
.
.
.
.
.
for 5 seconds.
for 1 second.
.
(there are 4 channels).
.
until