Charging - Remington EYE BALL R1 Owner's Manual

8

Charging

Using a charger
IMPORTANT: Use the chargers only within a temperature
range of 32°F to 113°F (0°C to 14°C).
Tip: The two chargers are identical. They can be used to
charge both the PDU and RVs.
Before charging: Attach the power cord to the charger. Do not connect the charger

to a power receptacle until directed to do so in the charging instructions.
After charging: Detach the power cord from the charger. Store the charger and

power cord in the R1 carrying case.
To charge the Personal Display Unit
1. If the Personal Display Unit (PDU) is on, turn it off: press the Power button
(in the upper left corner) for 2 seconds.
2. Connect the Charger Plug to the PDU's
Charging Jack.
3. Plug the Charger into a 110 or 220VAC
receptacle (the charger automatically
adjusts to the available voltage).
4. Charge the PDU for at least 5½ hours. Charger LED is red during charge, and green
when finished. Charging will stop automatically when the battery is fully charged.
Tip: You can use the PDU while it is charging, but the PDU
must be off when the charger is first turned on.
5. Remove the Charger from the receptacle.
6. Disconnect the Charger Plug from the PDU.
Charging Jack