Remington EYE BALL R1 Owner's Manual page 17

B. Deploy the Remote Viewer
1. Remove the Remote Viewer (RV) and the Personal Display Unit (PDU) from their
carrying case.
2. Turn on the PDU: press and hold the Power button
corner) for about 2 seconds.
3. Rotate the PDU antennas into the
approximate positions shown at right.
Notice that the antennas are not parallel.
Note: Leaving the antennas folded
along the PDU sides drastically
reduces operating range.
4. Turn on one of the RVs: remove the Pull Pin from
the rear of the RV. The RV initializes, during which:
Illumination LEDs turn on constantly or flash

(flashing indicates battery is nearly depleted,
and will power the RV for about ½ hour or less).
RV transmits video and audio for about

2 seconds.
RV rotates right, then left.

RV enters Standby mode.

5. Repeat step 4 for the other RV.
6. Press the Standby button
7. Verify that the PDU is receiving video from the RV.
Pull Pin
once or twice to display video from the RV.
Using
(in the upper left
Charging Jack
continued
15