Remington EYE BALL R1 Owner's Manual page 13

A. Check operation
If the Eye Ball RV and PDU are fully charged, they should
be ready for use at any time (see section B). If conditions
permit, however, check system operation before deploying
the Remote Viewer.
1. Remove the Remote Viewer (RV) and the Personal Display Unit (PDU) from their
carrying case.
2. Turn on the PDU: press and hold the Power button
corner) for about 2 seconds.
3. Rotate the PDU antennas into the
approximate positions shown at right.
Notice: PDU antennas should be held at a minimum of 7.9 inches (20 cm) or more from the body of all users.
Note: Leaving the antennas folded
along the PDU sides drastically
reduces operating range.
4. Turn on one of the RVs: remove the Pull Pin from
the rear of the RV. The RV initializes, during which:
Illumination LEDs flash briefly.

RV transmits video and audio for about

2 seconds.
RV rotates right, then left.

RV enters Standby mode.

5. Repeat step 4 for the other RV.
Note: The Eye Ball R1 System is now ready for use. To
perform a more thorough check, continue with steps 6–13.
(in the upper left
Pull Pin
11
Using
Charging Jack
continued