Remington EYE BALL R1 Owner's Manual page 11

To charge a Remote Viewer
1. Remove the Pull Pin from the Charging Jack
on the rear of the RV.
Removing the Pull Pin turns on the RV. The
Illumination LEDs will flash briefly.
2. Connect the Charger Plug to the RV's Charging Jack.
3. Plug the Charger into a 110 or 220VAC receptacle (the charger automatically adjusts
to the available voltage).
4. Charge the RV for at least 2 hours. Charger LED is red during charge, and green
when finished. Charging will stop automatically when the battery is fully charged.
Tip: You can use the RV while it is charging.
5. Remove the Charger from the receptacle.
6. Disconnect the Charger Plug from the RV.
7. Insert the Pull Pin in the Charging Jack on the rear of the RV.
IMPORTANT: When charging is complete, you must insert
the Pull Pin in the Charging Jack to turn off the RV. If you
leave the Pull Pin out the RV will discharge.
Pull Pin
9
Charging
Charging Jack