Lorex LW1741 User Manual page 12

4 Installing the Camera(s)
3. Loosen the adjustment ring on the metal camera stand(s) and move the camera to the
desired position. Tighten the adjustment ring when finished, holding the camera firmly
in position.
4. Connect one end of the camera's power adapter to the camera and the other end to an
electrical outlet or surge protector. Make sure the power connector is fully inserted to
avoid water getting in the plug.
Note
Power cables are only weatherproof when fully inserted at the connection point. Power cables may
not be submerged in water.
5. Remove the protective film from the front of the camera. If the film is not removed, it will
block the built-in microphone and affect the quality of the picture.
#LX400030; r.16602/16610; en-US
8