Reverse Function; End Points - Fly Sky FS-i6X Instruction Manual

Throttle (Left Stick Up/Down)

5.2 Reverse Function

The reverse function changes a channels direction of movement
in relation to its input. For example, if a servo has to be
mounted upside down due to space restrictions within a model,
this function can be used to correct its movement so that it
matches up with the user controls.
Setup:
1. To change between normal and press the "OK" key until the
desired channel is selected, then use the "UP" and "DOWN"
keys to change setting.
Nor = Normal, Rev = Reverse.
2. Hold the "CANCEL" key to save and return to the previous
menu.
3. To return to default settings press and hold the "OK" key for
3 seconds.Press and hold the"CANCEL"key to save.

5.3 End Points

The end points function changes the range of movement available to a channel. This can be used to
prevent damage to a model when a servo moves too far, potentially leading to damage to pushrods etc.
The left box is the low end point, the right box is the high end point, marked below as low being blue and
red being high.
Setup:
1. Press the "OK" to change channels.
2. Move the channel using its stick or knob to select the low
or high side.
3. Use the "UP" and "DOWN" keys to increase or decrease the
value.
4. Hold the "CANCEL" key to save and return to the previous
menu.
5. To return to default settings press and hold the "OK" key
for 3 seconds.Press and hold the"CANCEL"key to save.
THROTTLE UP
THROTTLE DOWN
15