Web-Based Configuration Utility - RocketFish RF-HTN102 User Manual

Web-based configuration utility

After you have made an initial Wi-Fi connection to your router, you might need to adjust settings on the hub. This section explains how to adjust the configuration using the
web-based configuration utility.
If you successfully established a Wi-Fi connection, go to Configuring the hub on page 17 to continue.
If you were unable to establish a Wi-Fi connection, follow these steps to connect directly to the hub. Before you begin, make sure that your computer is connected to the
hub using an Ethernet cable. Connect one end of the cable to the network adapter on your computer and the other end to one of the network jacks on the back of the Wi-Fi
Invite Home Hub.
Setting the computer's IP address
The RF-HTN102 does not have a DHCP Server. Therefore, the first time you connect your computer to the hub, the hub will not be able to give you a local IP address. You
will need to manually set your IP address to a local one in order to connect to the hub.
- Click Start > Settings > Control Panel. Select Network Connections. Select the connection profile which is connected to the hub, most likely labeled
Local Area Connection.
- Select Internet Protocol (TCP/IP) and click Properties. Select the radio button Use the following IP address and give the connection a local IP address
which is not in use already e.g. 192.168.1.111. Set the Subnet Mask to 255.255.255.0. Click OK twice.
- Try to connect to the web-based configuration utility again.
17