Configuration; Configuring Wps (Wi-Fi Protected Setup) - RocketFish RF-HTN102 User Manual

Using Wi-Fi to connect to a router
You can connect the Wi-Fi Invite Home Hub to your router using either Wi-Fi Invite or Wi-Fi Protected Setup (WPS). Once a Wi-Fi connection is successfully established, you
are ready to begin using your Wi-Fi Invite Home Hub.
Using WPS
The Wi-Fi Protected Setup (WPS) system is a simplified method for:
Securing your wireless network during the initial setup
•
Adding a new device to the network
•
There are two simple methods to securely add a device to your network via WPS:
• Push Button Configuration (PBC) method
• Personal Identification Number (PIN) Code method.
Both of these WPS methods greatly reduce the time it takes to get a new device on your network while using WPA2 encryption.
To connect to a wireless router using the PBC method:
1. Position the router and hub together for the initial Wi-Fi connection procedure.
2. Power on the router and wait approximately 1 minute for it to start before powering on your Wi-Fi Invite Home Hub.
3. Press the CONNECT button on the front of the Wi-Fi Invite Router. On other brands of routers, there will be a similar button for the WPS function.
4. Press Connect next to PBC near the bottom of the screen, or hold down the Connect button on the front of your Wi-Fi Invite Hub for approximately 3 seconds. The
two devices will connect within 2 minutes.
5. Place the hub in the desired location when the connection is successful.
To connect to a wireless router using the PIN Code method:
14