Simulate Thermocouples - Fluke 714B User Manual

Simulate Thermocouples

Connect the Product TC input/output to the instrument
under test with thermocouple wire and the appropriate
thermocouple mini-connector (polarized thermocouple
plug with flat, in-line blades spaced 7.9 mm [0.312 in]
center to center).
Note
One pin is wider than the other. Do not try to
force a miniplug in the wrong polarization. Figure
8 shows this connection.
Shop for Fluke products online at:
Proceed as follows to simulate a thermocouple:
1. Attach the thermocouple leads to the appropriate TC
miniplug, then to the TC input/output as shown in
Figure 7.
2. If necessary, push
3. Push
pushing this key to select the desired thermocouple
type or mV.
4. Enter the value you want by pushing
Push
MyFlukeStore
www.
Thermocouple Calibrator
Simulate Thermocouples

for Source mode.
 for the TC display. If desired, continue
 and
 and  to select a different digit to edit.
1.888.610.7664
.com
 .
19