Table of Contents
Advertisement
1. Connect all the sources to the DVI, USB, and audio inputs on the 4x4 DVI DL KVM
Matrix, using the supplied cables.
2. Connect the HDMI/DVI display, USB, and audio to the outputs on the 4x4 DVI DL
KVM Matrix.
3. Connect the 5VDC power supply to the 4x4 DVI DL KVM Matrix.
4. Controlling the 4x4 DVI DL KVM Matrix using the RMT16-IR:
Pressing Buttons...
13-16
*Note for computers connected to the DVIKVM Matrix - When your computer boots
up, it looks for an EDID (extended display identifi cation data) from the display to tell it
what monitor is connected and what resolution to output. During boot up of the comput-
er you should have ONLY one output selected to one input at a time so that the comput-
er gets the EDID of the display that is selected. If you have multiple outputs selected to
one computer, the computer will read the EDID of the last output selected to it. If all your
displays are the same, or all displays are
capable of running at the same resolution then this step does not matter.
You can also use a DVI Detective to eliminate the need to have that matrix selected to
the computer during bootup.
USING THE 4x4 DVI DL KVM MATRIX
1-4
Display 1 to view Source 1, 2, 3, or 4
5-8
Display 2 to view Source 1, 2, 3, or 4
9-12
Display 3 to view Source 1, 2, 3, or 4
Display 4 to view Source 1, 2, 3, or 4
Switches...
4
Advertisement
Table of Contents
