RMT-MATRIX-444 units with the EXT-DVIKVM-444 to have the ability to switch at all four remote workstations. The RMT-2-CAT5 now gives your Gefen 4x4 Matrix box the power of remote switching. The RMT-2-CAT5, in conjunction with up to four RMT-MATRIX-444 units, will extend your ability to manage your sources at each remote display. It will work with any of our 4x4 matrix untis listed below.
Page 5
FEATURES FEATURES • Remote switching of sources on compatible products INCLUDES: RMT-MATRIX-444 (1) RMT-MATRIX-444 (1) 10ft CAT5e cable (1) User manual RMT-2-CAT5 (1) RMT-2-CAT5 (1) 5V 2 Amp power supply (1) User manual...
1. Connect a CAT5/6 cable between the RMT-MATRIX-444 and one of the CAT5 ports on the rear of the RMT-2-CAT5. The ports are labeled as RMT 1, 2, 3, and 4, which correspond with any of our matrixs’ 1, 2, 3, and 4 display outputs.
The RMT-MATRIX-444 has a RS-232 serial port for control by external serial devices. Use the table below to setup your external serial control device. Binary Table ASCII Corresponding Display/Source RS232 Settings Bits per second ...19200 Data bits ... 8 Parity ... None Stop bits ...1 Flow Control ...