Instructions Pertaining To A Risk Of Damage To The Machine - ergoline SUN SELECT 1400 Operating Instructions Manual

10/2013 1014906-00
NOTE:
Occasionally, persons using the tanning device will experi-
ence a slight reddening of the skin – usually in small patches
– after the second or third session. This redness is often
accompanied by an itching sensation. This may be nothing
more than a very limited heat 'rash' caused by heat from the
lamps within the device and it should go away within
approximately 24 hours and not reappear. This rash can
be lessened or prevented by applying moisturizing lotion to
the affected area after the tanning session is completed.

Follow instructions.

The time between the first two tanning sessions must be
at least 24 hours.

Increasing tanning also requires an extension of the
exposure time (= radiation time). After a certain degree
of tanning has been achieved a further intensification is
not possible. The session time may not be extended to
exceed the scope of the permissible radiation doses!
Only a certain degree of tanning, dependent on the skin
type, can be achieved without endangering your health.

Inform users about proper tanning.
3.3 Instructions pertaining to a risk of
damage to the machine
CAUTION!
Danger of overheating by obstruction of the air routing!
– Do not change, obstruct or block the air inflow and
outflow area to the device or make any unauthorized
changes to the device. The manufacturer shall bear no
liability for damage or injuries resulting from such ac-
tions.
– Before putting a tanning device into operation, the
transport pallet must be removed from under the de-
vice. Danger of overheating by obstruction of the air
routing.
Safety notes
Operating instructions – 11/76