Programmings For The Installer; Setting Of The Doors Locking/Unlocking Time; Doors Locking Activation/Timed Status; Time Of The Status Signal If Timed - MED 2200 User Manual

ULTRASONIC SENSOR SENSITIVITY
2 Low
3 Medium - standard setting
4 High

SETTING OF THE DOORS LOCKING/UNLOCKING TIME

5 0,8 seconds locking / unlocking - standard setting
6 3 seconds locking / unlocking
7 10 seconds at locking - 0,8 seconds at unlocking
8 30 seconds at locking - 0,8 seconds at unlocking

DOORS LOCKING ACTIVATION/TIMED STATUS

9 Simultaneous / Delayed - standard setting
FIXED/TIMED STATUS SIGNAL
10
Timed (10 sec. Standard) /

TIME OF THE STATUS SIGNAL IF TIMED

11 10 seconds - standard setting
12 30 seconds
13 45 seconds
DOUBLE CONTROL FOR DOORS LOCKING
14 Activation / Cutting out - standard setting
DELAYED INPUT OF DOORS BUTTON TO POSITIVE/NEGATIVE
15 Positive / Negative - standard setting
DELAYED TIME ON ACTIVATION BUTTONS AND MODULES INPUT
16 50 seconds / 30 seconds - standard setting
AUTOMATIC ACTIVATION OF THE ENGINE LOCK
17 Cutting out - standard setting
Activation /
WAY TO ACTIVATE THE AUTOMATIC ENGINE LOCK
18 Delayed to 5 minutes /
ALARM OUTPUT
19 Fixed / Intermittent - standard setting
TEST
20 Modules
21 Buttons
22
Ultrasonic sensor
ULTRASONIC SENSOR
23 Cutting out / Activation - standard setting
ANTI-TAMPERING OF THE ULTRASONIC SENSOR
24 Activation - standard setting
Cutting out /
ODOMETER/MODULES PROGRAMMABLE INPUT
25 Delayed alarm input for modules
26 Pre-alarm input for dual-zone modules
27 Odometer - standard setting
ABSORPTION SENSOR
28 Activation / Cutting out - standard setting
ANTI-CAR JACKING
29 Cutting out - standard setting
Activation /
30 Automatic / Manual - standard setting
31 Activation times: Long /
DIRECTION INDICATORS CONTROL
32 With 2 wires by relays separated channels (right/left side separated) - "USUAL CONNECTION"
33 Single negative control with starting and final blinking IMPULSE - standard setting
34 Single negative CONTINUOUS control
RESET OF THE INITIAL CONDITIONS PROGRAMMED AT DEFAULT
35 Standard values setting
AUTOMATIC ANTI HI-JACK FUNCTION:
36 Activation / Cutting out - standard setting
MED 30.x DIGITAL IMMOBILIZER
40 Replacement of the alarm central unit paired with the immobilizer of the

PROGRAMMINGS FOR THE INSTALLER

Fixed - standard setting
Immediate - standard setting
Short - standard setting
It's active also when the door is opened with started engine
(on MUX line)
MED 30 series
28