Activation/Desactivation Systems; Remote Controls; Electronic Keys; Electronic Key Operation - MED 2200 User Manual

3 soft(slow) pressures
relighting, followed by a high/low two tone signal for confirmation.
To set or change the speed during the running:
- Reach and keep the chosen speed.
- Press the LED button for about 3 / 4 seconds till the confirmation signaling (some quick, low
BEEPS) ends.
From this moment, an extended BEEP and the LED relighting fixed warn on the exceeding of the
preset speed.
The chosen speed limit remains stored till a new one is set with the same procedure, even if the
engine is turned off.
To cut out the signaling, make the programming shown above (press the LED button 3 times).
WARNING:
- The signaling is only a warning, it does not operate on the engine working.
- Pay always the maximum attention during the driving.
- Do not let that the speed setting and the warnings could distract you from driving.
- The signaling tolerance (more or less high speed compared to the chosen one) may vary
according to the vehicle's features and the speed.
- No signaling for too low speeds: under 10 / 15 Kmh.
THE FOLLOWING INSTRUCTIONS ALLOW A DEEPER

ACTIVATION/DESACTIVATION SYSTEMS

REMOTE CONTROLS

They activate/desactivate the system from distance, unlock and lock the doors, control the
windows closing and the paired additional optional modules. They are sealed, antiscanner,
ROLLING CODE and self-learning. Those in the box are ready to use. It is possible to use up to 3
pieces simultaneously, cancel the lost and pair some other, new ones (please ask your installer).
Their duration with normal working is about 5 years. To allow the internal battery to last longer,
use both regularly, avoiding to let one of them unused for years.

ELECTRONIC KEYS

They activate/desactivate the system, control the windows closing and the paired additional
optional modules (in combination with the LED button).
They re-set the system after the ANTI-CAR JACKING mode, allowing the engine to start again.
They are antiscannner, self-learning and ROLLING CODE.
Those in the box are already working. It is possible to use up to 2 pieces simultaneously, cancel
the lost and pair some other, new ones (please ask you installer).

ELECTRONIC KEY OPERATION

Put and press the key on its key socket (the two metallic parts have to come in contact). During
the "contact" the LED switches on flashing quickly.
SYSTEM ACTIVATION BY THE ELECTRONIC KEY
Press it on its key socket: the LED switches on slightly "vibrating", then, once detached the key, it
remains lit fixed and the buzzer gives a continuous hiss ending with the usual signaling of the
system activation, after about 20 seconds.
- The procedure will cut off putting the key again on its key socket or turning the ignition key on.
- The system activates itself completely, except the doors locking.
Lock the doors using the vehicle's original system (key or original remote control).
SYSTEM ACTIVATION BY THE ELECTRONIC KEY EXCLUDING THE ULTRASONIC
SENSOR, THE WINDOWS CLOSING AND THE MODULES
Turn the key in off position or open a door.
Press the LED button while it is lit fixed till the end of the confirmation given by an acoustic two
tone signaling (LED switched off with pressed button).
desactivate it: each time confirmation with one BEEP and the LED
KNOWLEDGE OF THE SYSTEM
18